ZANKER KEV6340FBB Uživatelský manuál stáhnout pdf (Strana 18)

Problem Possible cause Remedy

The appliance deactivates. You put something on the sensor

field

Remove the object from the sensor

field.

The residual heat indicator does not

come on.

The cooking zone is not hot be-

cause it operated only for a short

time.

If the cooking zone operated suffi-

ciently long to be hot, speak to the

service centre.

The sensor fields become hot. The cookware is too large or you

put it too near to the controls.

Put large cookware on the rear

cooking zones if necessary.

comes on.

The Automatic Switch Off operates. Deactivate the appliance and acti-

vate it again.

comes on.

The Child Safety Device function

operates.

Refer to the chapter “Daily Use”.

and a number come on.

There is an error in the appliance. Disconnect the appliance from the

electrical supply for some time. Dis-

connect the fuse from the electrical

system of the house. Connect it

again. If

comes on again, speak

to the service centre.

If you tried the above solutions and cannot repair the

problem, speak to your dealer or the customer service.

Give the data from the rating plate, three digit letter

code for the glass ceramic (it is in the corner of the

glass surface) and an error message that comes on.

Make sure, you operated the appliance correctly. If not

the servicing by a customer service technician or dealer

will not be free of charge, also during the warranty peri-

od. The instructions about the customer service and

conditions of guarantee are in the guarantee booklet.

Installation

Warning! Refer to the Safety chapters.

Before the installation

Before the installation of the appliance, record the infor-

mation below from the rating plate. The rating plate is on

the bottom of the appliance casing.

• Model ...........................

• PNC .............................

• Serial number ....................

Built-in appliances

• Only use the built-in appliances after you assemble

the appliance into correct built-in units and work sur-

faces that align to the standards.

Connection cable

• The appliance is supplied with the connection cable.

• Replace the damaged mains cable with a special ca-

ble (type H05BB-F Tmax 90°C; or higher). Speak to

your local Service Centre.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Komentáře k této Příručce

Žádné komentáře

ZANKER KEV6340FBB Uživatelský manuál Strana 18

Komentáře k této Příručce

Související produkty a manuály pro Sporáky ZANKER KEV6340FBB